Brass Pendulum Wheel Knuckle Axle Weight with Alloy Lid + 23mm Hex Adapter 2-pcs

• 23mm Hex Adapter-2PCS
• Stainless Steel Screw Shaft M4x2.5x11.8-2PCS
• 5mm stainless steel Shims-2PCS
• 5mm Metal Washer-2PCS
• 20mm Stainless Steel Hex Socket Screws-2PCS

Product major function & usage:
To increase the weight of each wheel to stabilize the wheel, enlarge the angle of crawling, especially when the car is digging into some low lying area landscapes, grab the ground firmly and smoothly drive back to level.

Major advantages of upgrading to this product:
1. Stainless steel rolling beads design to carry additional weight (66 to 86 grams) for each wheel, keeping the weight downward towards the ground for better grabby performance.

2. The high quality of the stainless steel is very suitable for muddy watery track with no fears of getting rusty.
3. To adjust the weight of the pendulum wheel, there are 8 removable stainless steel beads, weighing 4g each.

The features of general appearance of this product:
Stainless steel rolling beads design to carry additional weight (66 to 86 grams) for each wheel, keeping the weight downward towards the ground for better grabby performance. The high quality of the stainless steel is very suitable for muddy watery track with no fears of getting rusty.

Other special notes and comments
Install onto front & rear outer case of the knuckles, this part does not appear in the original and it is a sophisticated design for TRX 4 by GPM. The pendulum design offers a consistent downward force.

Weight per piece : 66-86 grams (includes 8 rolling beads, we recommend keeping at least 3 beads for better performance)
23mm widen hex adapter (18mm wider than original).

We use a quality light weight high tensile strength aluminum 6061 T6 and is then anodized with scratch resistant colors