CNC machined from aluminum and anodized black. The slipper eliminator kit weighs only 3.26gr, which is approximately the same as the MIP Slipper kit w/ factory spring (that's not used with the eliminator).

Zero spur gear modification needed, which allows easy switching between locked spur or original slipper as track conditions warrant. Simply remove your stock slipper components and install the eliminator. Make sure the halves are properly seated in the hex of the spur gear.

Works with the stock top shaft or the MIP top shaft.

If you have trouble eating through slipper pads or want that instant punch that a slipper eliminator provides, then this is for you. Great for oval racing, speed runs, dragster style setups**.



**Note: The slipper clutch was originally designed as a gearbox saving device that can help save the transmission gears when the motor engages under a heavy load (high power start, off the corner, landing off a jump, etc). Removal of this can potentially cause damage to internal gears, stripped spur gears, etc. This is a run-at-your-own-risk part and HackFab is not liable for any damage that may be incurred by the use of this part.